Following the advice across several Caterham builder blogs, I decided to fit the IVA trim to the chassis suspension apertures sooner rather than later. The official manual moves directly from putting the chassis on axle stands into installing the suspension wishbones and steering rack, but once those components are bolted in place, getting your fingers and tools into the cut-outs becomes a nightmare. Doing it now while access is wide open makes total sense.
Getting Into the Rhythm
Fitting the rubber U-channel trim is undeniably fiddly to begin with. However, after working through the first two or three cut-outs, I started to find a steady rhythm and got the hang of how the rubber seats onto the aluminium edge. By the time I finished, the finish looked neat and tidy. It is definitely a specific skill learned on the job—and hopefully one I will never have to use again.
IVA Minimums vs. Full Perimeter Trimming
From my understanding of the IVA requirements, edge protection is strictly only required along the forward-facing and upper edges of these suspension cut-outs to satisfy the external projection rules.
Despite that, leaving the bottom and rear edges bare leaves raw aluminium exposed, so I chose to run the trim all the way around the entire perimeter of each aperture. A couple of practical observations if you take this route:
It is noticeably more fiddly to work the trim around the tighter radii and lower corners.
When you measure, cut, and join the ends, you will likely end up with a tiny hairline gap where the two ends meet, but it still looks far cleaner and more finished than leaving bare metal edges.
Glue Usage and Protecting the Bodywork
For anyone wondering about consumables: one small bottle of standard superglue is plenty to complete all the front suspension apertures. You do not need to buy extra pots for this stage.
A couple of practical tips while working with adhesive in these areas:
Mask the painted skin: Apply masking tape to the painted bodywork immediately adjacent to each aperture before you start. It is remarkably easy to get a stray smear of superglue onto the aluminium side panels, and cured glue will ruin the finish.
PPE: Wear disposable nitrile or latex gloves when dabbing the glue into the channel to avoid bonding your fingers to the trim or the chassis.
The Exhaust Aperture Question
One area I have not tackled yet is the side aperture for the exhaust primaries. I cannot quite work out whether this opening actually requires IVA trim. Given how hot the exhaust primaries get right at the exit of the engine bay, running standard rubber or plastic trim around that cut-out seems like a bad idea due to the heat.
I plan to do a bit more research through the community forums and check Caterham's specific guidance on exhaust cut-out compliance before deciding whether to trim it or leave it bare.
Update - it's not required - see my correspondance with Lee
With the suspension holes prepped and the glue set, the next job is getting the wishbones and front suspension hardware unbagged and bolted up.

Comments
Post a Comment