In principle, fitting the front brake hoses should be a quick and straightforward job. The rigid copper brake lines are already pre-installed along the chassis, so the task simply involves running the braided flexible hoses from the front calipers through the chassis side panels and connecting them up to the hard lines. In practice, however, it turned out to be one of those frustrating jobs where small discrepancies and alignment issues slow everything down.
Unpacking and the Grey Adapter Query
The brake hoses arrived packaged with the brake kit. Before assembling anything, the manual notes to discard the standard gold adapters and install the grey stepped adapters designed to locate the sealing washers correctly against the calipers.
When inspecting the parts, I found that the grey adapters were already fitted to the brake hoses straight out of the box. While this seemed like a helpful step from the factory, you cannot afford to make assumptions when dealing with the braking system. Rather than guessing, I paused the job and emailed Lee at Caterham to confirm that the pre-installed fittings were indeed the correct stepped grey adapters and safe to mount as supplied.
Once confirmation came through, I moved on to fitting the hoses to the chassis.
![]() |
| The ones pre-attached are correct - no idea what happened to the gold ones ! |
![]() |
| The correct copper washer (I hope) |
The Driver-Side Brake Line Misalignment
Mounting the hose involves passing the threaded union through the dedicated hole in the chassis panel, secured with a plain washer on the outside and a shake-proof washer and locknut on the inside, where it meets the hard copper brake line.
On the passenger side, this went together without issue. On the driver's side, however, the pre-installed copper brake pipe and the chassis aperture did not line up cleanly—the pipe was off-center by roughly 5 mm.
Hard copper lines can be notoriously tricky; forcing them risks kinking the pipe or cross-threading the union nut, either of which ruins the line. I spoke to Dan, the build support specialist at HWM, to get a steer on how much manipulation the line could take. He confirmed that the copper pipe could be eased into position gently, but reiterated the critical warning: under no circumstances force the union nut if the threads aren't biting cleanly by hand, as cross-threading the brass fitting is an instant failure.
The Fix: Finding Wiggle Room
Trying to thread the hard line into a hose adapter that was already firmly bolted to the chassis was a recipe for cross-threading. To solve the misalignment safely, I adopted the following sequence:
Loosen the chassis retaining nut: Back off the 3/8" locknut holding the hose union to the chassis side panel so the fitting can move freely in its hole.
Engage the copper hard line first: With that extra play, gently ease the copper pipe until it sits completely square against the adapter face. Spin the union nut in entirely by hand to ensure the threads catch smoothly with zero resistance.
Tighten the union: Once hand-tight and properly engaged, nip up the hard line union securely with a flare spanner.
Lock down the chassis mount: With the brake pipe seated stress-free, tighten the chassis locknut against the inside shake-proof washer to secure the assembly to the side skin.
| Undid the chassis fixing bolt, connected the copper union, then re tightened. Its quite out before ! |
Post-Build Peace of Mind
This approach took all the tension out of the joint and ensured the union mated perfectly square without damaging the soft threads.
Before moving on, I carried out the standard check: turning the steering from lock to lock to confirm that the braided hose forms a natural forward arc and does not foul against the suspension wishbones or damper bodies at full travel.
While the connection feels solid, leak-free, and correctly aligned, brakes are the one system where zero doubt is acceptable. I have added this connection to my build notes for Dan to double-check specifically during the official Post-Build Check (PBC) before any fluid goes into the system.


Comments
Post a Comment