Installing the Heater
The heater installation turned out to be a relatively straightforward job, much like other builders have suggested. As noted in the community assembly guides, the first required step is to take the battery out. This is a very simple job and is absolutely essential to give yourself the clearance needed to slide the heater unit into place.
![]() |
| Don't get this far before adjusting and tightening the cable ! |
Riveting the Cable Clip
For me, the most daunting part of the process was attaching the cable cradle clip to the heater casing. The manual instructs you to drill a hole into your shiny new plastic housing and secure the clip with a rivet.
This happened to be the first rivet I had ever installed. I initially borrowed an old rivet gun from a mate, but after testing it on some blank plates, I realised it wasn't working correctly. I went out and bought myself a new Magnusson rivet gun, which functioned excellently, but it introduced a new challenge.
Rivet guns typically come with either flat or conical nose pieces. My new tool had flat heads, which unfortunately meant the nose couldn't fit inside the two small raised wedges of the supplied cable tie clip. During my initial attempts to make it work, drawing the rivet through actually enlarged the hole I had drilled in the plastic.
![]() |
| Hopefully the rest of the rivet locations will allow my gun to fit ! |
To solve the problem, I dug into my spares box and found a suitable plastic replacement clip that allowed clearance for the flat-nosed gun. Because the hole in the heater casing was now slightly oversized, I purchased a batch of slightly larger rivets. In the end, this workaround provided a very neat and secure solution.
![]() |
| Alternative clip solution |
Adjusting the Heater Control Cable
Another crucial step is setting up the heater control cable at the brass heater control valve. The valve has a clamp and an adjustment screw that secures the outer cable. You need to position the cable carefully so that when you push and pull the control knob in the cockpit, the valve sweeps completely between its fully open and fully closed positions.
A quick tip on the order of assembly: I initially attached all the hoses and mounted the valve in place before fully tightening the cable clamp. Once everything was plumbed in, I realised I couldn't actually reach the screw to tighten it.
To resolve this, I had to detach the brass heater valve from the pipework, set the cable adjustment and clamp it down securely, and then reinstall the valve assembly. It wasn’t a terribly difficult fix, and I was pleased to have worked it out quickly, but it’s a sequence error you can easily avoid.
Key Takeaways for this Stage:
Remove the battery first to ensure you have enough room to maneuver the heater assembly.
Check your rivet gun clearance before drilling into the plastic housing. If you have a flat-nosed rivet gun, you may need a different cradle clip or to secure the cable elsewhere.
Set and tighten your cable adjustments on the brass heater valve before you permanently plumb it into the hoses, or you will block your own tool access.



Comments
Post a Comment