With the main drivetrain components coming together, it was time to install the propshaft and tackle the rear axle. Overall, this was a manageable job, though it required a bit of research and clarification to get the brake plumbing correct.
![]() |
| These are 'captive washers' |
The gearbox end of the propshaft is incredibly simple to install. Once the protective bung is removed from the gearbox tail, the propshaft simply slides directly onto the splined output shaft of the gearbox. There are no mechanical fixings required at this end; it is held in place by the splines.
Securing the differential flange requires a bit more attention. The assembly manual wasn't entirely clear on which specific fasteners to use for this connection. After cross-referencing with the builder forums, I realized the required fasteners were bolts featuring a captive washer—a washer that is permanently pressed or moulded onto the bolt head. With the correct hardware identified, I was able to bolt the differential together, and attach it to the axle.
![]() |
| So this is now 'captive' ! |
Suzuki Axle and Brake Line Routing
Moving on to the rear axle, I ran into a discrepancy between the provided manual and the parts supplied. Caterham has upgraded the brake line routing for the Suzuki rear axle.
According to the older manual, there should be a single, continuous copper brake tube running horizontally across the axle. However, the upgraded system splits this into two separate hard brake lines connected in the middle by a connector bolt (a threaded union).
![]() |
| This is NOT how the manual shows it - and thats what that bit is for ! |
Earlier in the build, I had noticed this connector bolt sitting in a random miscellaneous parts bag and wondered what its purpose was. Because my manual didn't illustrate this updated two-piece setup, I reached out to Lee at Caterham for clarification. He explained how the new brake lines plumbed together. Once I understood the updated routing, putting it together was straightforward.
While I am learning that I can usually deduce how a part fits by looking at the components, the braking system is not an area where I want to rely on guesswork.
Final Brake Connections
After a bit of trial and error and some help from Lee, I realised I’d put the brake line connection length on the wrong way round, or more accurately “you did have the braided hose fitted the wrong way around. The floating union fits into the 3-way and the fixed union into the copper pipe”.
![]() |
| It should NOT look like this |
The speed sensors were also not the same as the manual, and again Lee helped: “the speed sensors are no longer handed. You will need to remove the metal and plastic clips from both sensor wires. These are Suzuki fixings and are not used in the Caterham install. Once fitted, the sensor wiring can then be secured along the diagonal chassis tubes along with the chassis harness.”
![]() |
| YOu need to physically remove these extra fittings |
![]() |
| And then cable tie to tidy up ! |
They were a reasonably easy fix, although it does look a bit heath robinson having them and the handbrake cables cable-tied to various chassis parts, but thats how it’s done







Comments
Post a Comment